beautypg.com

Preparing the 10/100 ethernet port, Overview, Enable controller ethernet port – Xerox 8825 User Manual

Page 46: Network protocols supported, Tcp/ip, Software supported, Windows 95/98 platform, Windows 4.0 & 2000 platforms, Unix platform, Parallel port

background image

8825/8830 Controller Setup Manual for Firmware 6.0

30

Controller Overview (continued)

Preparing The 10/100 Ethernet Port

Overview

This port is standard on the all Controllers.

To print using this port your workstation must have a Network Interface Card
installed, protocols enabled, and appropriate software running.

Enable Controller Ethernet Port

Use the Setup I/O Ports menu of the Printer Control Panel to set the Ethernet
“Port Enable” to “ADVANCED.”

Refer to your Network Administrator or the 8825/8830/8855 Network
Administrator's Guide (available at

www.xes.com

) for additional information.

Network Protocols Supported:

TCP/IP

• lpr/lpd
• tftp and ftp

Software Supported:

WINDOWS 95/98 PLATFORM:

• HP-GL/2/RTL Print Driver

• ADI Driver for AutoCAD R13/14

• HDI Driver for AutoCAD 2000 and 2000i

• PostScript PPD System Print Driver

• Web Printer Manager Tool (Administration and Job Queue Management)

• AccXES Client Tools

• Web PMT (requires Firmware 4.0 release or higher)

WINDOWS 4.0 & 2000 PLATFORMS:

• HP-GL/2/RTL Print Driver

• ADI Driver for AutoCAD R13/14

• HDI Driver for AutoCAD 2000 and 2000i

• PostScript PPD System Print Driver

• AccXES Client Tools

• Web PMT (requires Firmware 4.0 release or higher)

UNIX PLATFORM:

• Web PMT (requires Firmware 4.0 release or higher)

• tftp puts and ftp

• lpr/lpd

support

• AccXES Client Tools (Solaris)