beautypg.com

Changing the postscript partition parameter, Purpose, Path to the postscript partition parameter – Xerox 8825 User Manual

Page 63: Making the postscript partition selection, Path to the tcp/ip options, Selecting the tcp/ip options

background image

8825/8830 Controller Setup Manual for Firmware 6.0

47

Changing the PostScript
Partition Parameter

Purpose

With the PostScript option installed in your printer, the size of the hard drive
partition can be increased (optimized) to provide more memory for PostScript
job processing as might be required for printing large and/or complex
PostScript jobs. Note, however, that by increasing the size of the PostScript
partition, the memory allocated for other partitions to handle such tasks as
spooling, building of copy sets, and scanning jobs to the net will be reduced
to accommodate the larger PostScript partition.

Path to the PostScript Partition
Parameter

At the Printer Control Panel, display shows , press [ON-LINE], display
, press [ENTER], display , press [ENTER], display
, press [NEXT], display .

Making the PostScript Partition
Selection

Press [ENTER], press the NEXT key to toggle between NORMAL and
POSTSCRIPT OPTIMIZED (the largest partition size option). Press [ENTER]
to confirm your choice. The display then indicates, PRESS [ENTER] TO
REBOOT, OR [EXIT] TO CANCEL.

• Pressing [EXIT] cancels the operation and leaves the disk untouched.

Press [ON LINE] to enable printing again.

CAUTION

Changing the partition option will cause the loss of any scanned documents
stored on the hard disk drive during previous scan-to-net operations.
Retrieve these documents before re-partitioning the hard disk drive.
• Pressing [ENTER] implements the selected change of partition.
The Controller will automatically reboot to re-partition the hard drive. The

display indicates, REBOOTING PLEASE WAIT...

When the display indicates IDLE, the printer is ready to use.