Xerox 8825 - Manual (Page 132)

8825/8830 Controller Setup Manual for Firmware 6.0 116
Configuring the Printer Processing Defaults (continued)
Raster Stamp X & Y Location Option
Purpose of Raster Stamp X & Y Location Option
The X coordinate sets the position of the left side of the raster stamp on the
printed page. The X coordinate can be specified as a value in millimeters or
set to CENTER, LEFT, or RIGHT. The X coordinate is determined after any
rotation of the stamp as specified by the RASTER STAMP ROTATE option.
Range: 0 - 30480mm, LEFT, CENTER, RIGHT, or LEADING
Default: CENTER
The Y coordinate sets the position of the bottom side of the raster stamp on
the printed page. The Y coordinate can be specified as a value in inches or
set to TOP, CENTER, or BOTTOM. The Y coordinate is determined after any
rotation of the stamp as specified by the RASTER STAMP ROTATE option.
Range: 0 - 30480 mm, TOP, CENTER, or BOTTOM
Default: CENTER
PATH TO THE RASTER STAMP X & Y LOCATION OPTION
Display , press [ON-LINE], display , press [ENTER],
display , press [NEXT] until is
displayed, press [ENTER], display , press
[NEXT] until is displayed, press ENTER, press NEXT
until or is displayed.
SELECTING THE RASTER STAMP X & Y LOCATION OPTION
Press the ENTER key, then the NEXT key, to change the option. Press
ENTER to confirm.
EXITING THE RASTER STAMP X & Y LOCATION OPTION
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.