Setting the error page option, Error page purpose – Xerox 8825 User Manual
Page 79

8825/8830 Controller Setup Manual for Firmware 6.0
63
Configuring the Printer Setup Defaults (continued)
Setting The Error Page Option
Error Page Purpose
The purpose of this option is to enable the printing of Error Pages. Error
pages may prove useful when troubleshooting print job errors. The two levels
of error reporting are designated as level 1 and level 2. A brief description of
each level follows:
The LEVEL 1 selection prints an ERROR/WARNING page only when a hard
error exists that will not allow the data file to print. Level 1 is a visible
indication that a print job was received, but no output was produced because
of an error. When a hard error is encountered the controller reads in job
data, but then instead of processing, all the data related to the failed job is
discarded.
The LEVEL 2 selection prints an ERROR/WARNING page when any error
(hard and soft error) exists though the data file may print. Level 2 is a visible
indication that a soft error was encountered and the controller printed as
much of the job as it could, given the error condition. When a soft error
occurs, there is at least the possibility that some image data may be missing
in the print.
Note: An error/warning page always follows the job the produced the
error or warning. The error/warning page is always printed on the
narowest roll and cut to the smallest length that will contain the
information.
ENABLING OR DISABLING ERROR PAGE GENERATION.
The page will be printed on the job selected paper size.
Range: NONE, LEVEL1, or LEVEL2
Default: LEVEL1
PATH TO ERROR PAGE OPTION
Display
display
press [ENTER], display
SELECTING ERROR PAGE OPTION
Press the ENTER key to change the option. Press the NEXT key to select
LEVEL1, LEVEL2 or NONE, then press the ENTER key with the desired
selection displayed.
EXITING ERROR PAGE OPTION
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.