I/o ports, Section-by-section overview – Xerox 8825 User Manual
Page 32

8825/8830 Controller Setup Manual for Firmware 6.0
16
Controller Overview
Controller Specifications (N5T/CNG Product Code)
(continued)
I/O Ports
Serial
Two 9 pin Host serial ports provided. One is used by the
8825/8830 DDS scanner when this option is connected. The
second is used as an input port for receiving data via serial port
connection.
Note: For firmware releases 2.0, the upper serial port is used for
data input; the lower serial port is used for service.
For later releases, the upper serial port is used for connection to
the 8825/8830 DDS Control Panel if a scanner is detected during
startup. If a scanner is not detected during startup, the upper
serial port becomes the service port.
The lower serial port is used for data input.
Parallel
(IEEE 1284 Compliant) High density port connector provided.
SCSI
50 pin Ultra SCSI Connector provided.
VPI
37 pin D Connector provided.
Scanner
50 pin Ultra SCSI Connector provided.
Ethernet
Built-in 10/100 Ethernet Network Interface: RJ-45 connection,
supporting TCP/IP only.
Option
N5T has a legacy 3003-XTP Network Interface Card: RJ-45 and
Coax connections, with multiprotocol support, 10 Mb/s Ethernet
only. This card is now replaced by the optional External Ethernet
Adapter connected to the parallel port.
Important Note: For the location of the ports with the new N5T with Tag 3
Controller, see the illustration in the Controller Overview section of this
manual.