Xerox 8825 - Manual (Page 125)

8825/8830 Controller Setup Manual for Firmware 6.0 109
Configuring the Printer Processing Defaults (continued)
Setting the Set Mirror Image Option
Purpose of Set Mirror Image Option
The purpose of this option is set the desired Controller default mirror image
mode.
This option sets the default Mirrors mode that will be used when every image
is printed.
Range: MIRROR X, MIRROR Y, MIRROR XY, or MIRROR OFF
Default: MIRROR OFF
This image placement parameter is applied in the following priority order:
• Instructions embedded within a print job’s native data format are applied
with highest priority.
• Parameters specified through job control instructions (such as HP-PJL)
associated with the print job are applied next.
• Printer default parameters are applied to all remaining unspecified
parameters.
PATH TO THE SET MIRROR IMAGE OPTION
Display , press [ON-LINE], display , press [ENTER],
display , press [NEXT] until is
displayed, press [ENTER], display , press
[NEXT] until is displayed.
SELECTING THE SET MIRROR IMAGE OPTION
Press the ENTER key to change the option. Press the NEXT key until the
MIRROR IMAGE Selections Menu is displayed, then press the ENTER key.
EXITING THE SET MIRROR IMAGE OPTION
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.