Xerox 8825 - Manual (Page 17)

8825/8830 Controller Setup Manual for Firmware 6.0 1
Getting Started
Purpose of This Manual
The purpose of this manual is to provide the procedures needed to change
the default Controller settings if required. Depending upon the release
revision of your Controller’s firmware (i.e. 2.5, 2.7, 3.0, 4.0, 5.0, 6.0),
individual options may or may not be available. In addition, information is
provided for each port and protocol to aid in connecting remote workstations
to the 8825/8830 System.
Section-by-Section Overview
This manual includes the following sections:
• Getting Started - states the purpose of this manual and provides a
section-by-section overview.
• Controller Overview - this section details Controller components and
their functions.
• Accessing the Default Setup Menus - contains a sequential listing of
all the functional items in the menus of the Printer Control Panel.
• Viewing the System Configuration Defaults - contains procedures for
printing Test Prints which provide a permanent record of all current
system settings. This is a MANDATORY step required before
performing a Factory Default Reset or configuring the printer for
communications in a network environment.
• Configuring the System Communication Defaults – covers
procedures for enabling Controller ports and setting applicable
communication parameters.
• Configuring the Printer Setup Defaults – covers all of the settings of
the “Setup Printer” menu of the Printer Control Panel.
• Configuring the Printer Processing Defaults – covers all of the
settings of the “Processing Defaults” menu of the Printer Control
Panel.
• The System Administration Menu Options – covers the System
Administration menu options of the Printer Control Panel.
• Printer Menu Options – provides instructions for setting energy-
saving timers and for configuring the printer for use with a finisher
(folder).