Accessing the default setup menus, Quick menu locator, Getting to the 6 controller setup menus – Xerox 8825 User Manual
Page 50: Quick menu item locator, Utilities menu, The host serial port

8825/8830 Controller Setup Manual for Firmware 6.0
34
Accessing the Default Setup
Menus
Quick Menu Locator
The Controller status is one of three conditions as indicated by the display
panel. The conditions are: PAUSED, IDLE, and PROCESSING. All the
controller default setup menus must be accessed in the PAUSED mode.
Getting to the 6 Controller Setup Menus
Press the ON-LINE key, then the ENTER key. This displays the UTILITIES
menu. Press the NEXT key to step to a different menu. Press the ENTER
key when the desired menu is displayed to access the menu items. When in
the desired menu press the NEXT key to access the desired function.
Quick Menu Item Locator
UTILITIES MENU
TEST PRINT
ALL
PRINTER CONFIGURATION
PRINTER SETTINGS
PEN PALETTES
POSTSCRIPT (displayed when PostScript option is installed)
SYSTEM INFORMATION
JOB ACCOUNTING
DISPLAY REPORTS
POSTSCRIPT PARTITION
NORMAL
OPTIMIZED
NONE
JOB QUEUE
MISMATCH QUEUE
Notes:
The TEST PRINT set (ALL) consists of one sheet of PRINTER
CONFIGURATIONS, one sheet of PRINTER SETTINGS, 8 sheets of
PEN PALETTES, and one sheet of PostScript firmware information (if this
firmware is installed).
The TEST PRINT(s) will not be processed by the printer until the ON-
LINE mode is entered. The TEST PRINTS will be printed on ‘A’ size
paper when ‘ANY’ is the media default, otherwise the selected default
paper size is used.
Note: When the POSTSCRIPT PARTITION parameter is changed, the
controller will automatically reboot to re-partition the hard drive.