Xerox 8825 - Manual (Page 147)

8825/8830 Controller Setup Manual for Firmware 6.0 131
Printer Menu Options
For more information on Printer Menu Options, see the Xerox 8825/8830
Printer Operator Manual. The selections available with this menu only affect
the printer. They do not affect the Controller. Customer Service Engineers
use this menu when initially setting up your system, as well as for
troubleshooting the system when needed.
The parameters of the Printer Menu include: Audible Indicators, Timers,
Printer Adjustments, Finisher Settings, Diagnostics and Billing Meters.
Information on Timers and Finisher Settings is included in this section of this
Manual.
Setting The Timers
Purpose
The Timers are an energy-saving feature enabling you to set the elapsed
time in minutes that the printer will be allowed to remain idle at full standby
power before entering into power saver and rest modes. The READY TO
POWER SAVER timer lets you set the elapsed idle time in minutes before
the printer's fuser is set to low power. The POWER SAVER TO REST timer
lets you set the elapsed idle time in minutes before the printer's fuser is
switched OFF.
The range in minutes for the READY TO POWER SAVER timer is 5 to 50.
The range in minutes for the POWER SAVER TO REST timer is 15 to 150.
PATH TO SETTING THE TIMERS
At the Printer Control Panel when the display shows , press [ON-
LINE]. When the display shows , press [ENTER]. When the
display shows , press [NEXT] until is
displayed. Press [ENTER]. Press [NEXT] until is displayed.
Press [ENTER]. Use the [NEXT] and [PREVIOUS] keys to toggle between
READY TO POWER SAVER and POWER SAVER TO REST. Press
[ENTER] to enable you to use the [NEXT] or [PREVIOUS] key to set a value
in minutes for the selected timer. Press [ENTER] to confirm your selection
Press [EXIT] to escape the current menu. Press [ON-LINE] to put the printer
back on line.