Setting the media type set option, Setting the media size option, Media size purpose – Xerox 8825 User Manual

Page 124: Path to media size option, Selecting the media size option, Media type option purpose

8825/8830 Controller Setup Manual for Firmware 6.0

108

Configuring the Printer Processing Defaults (continued)

Setting the Media Type Set Option

Media Type Option Purpose

This option sets the default type of media that will be used for all jobs.

Range: BOND, VELLUM, FILM, or ANY

Default: BOND

Note: If a job is sent to the printer and the desired media type is not installed,
the user will be prompted to load the correct media type.

PATH TO MEDIA TYPE OPTION

Display , press [ON-LINE], display , press [ENTER],
display , press [NEXT] until is
displayed, press [ENTER], display , press
[NEXT] until is displayed.

SELECTING THE MEDIA TYPE OPTION

Press the ENTER key to change the option. Press the NEXT key to toggle
through the selections, and when the desired selection is displayed, press the
ENTER key.

EXITING THE MEDIA TYPE OPTION

Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.