Selecting the netbeui option, Exiting the netbeui option, The ipx/spx purpose – Xerox 8825 User Manual
Page 66: Configuring the ipx/spx frame setting, Ethertalk purpose, Path to ethertalk options, Selecting ethertalk options

8825/8830 Controller Setup Manual for Firmware 6.0
50
Configuring the System Communication Defaults
(continued)
Setting The EtherTalk options (Legacy
3003-XTP NIC)
EtherTalk Purpose
The purpose of this option is to set the multiprotocol 3003-XTP NIC to be
enabled to use the EtherTalk protocol. The 10/100 Ethernet card/port does
not support the EtherTalk protocol. All Controllers now use an optional,
external Ethernet Adapter to support EtherTalk.
Required settings when selecting the EtherTalk options:
This option enables the 3003-XTP NIC Ethernet port to use the EtherTalk
protocol.
Range: ON or OFF
Default: ON
This option selects the phase to be used with the EtherTalk protocol.
Range: PHASE 1, or PHASE 2
Default: Phase 2
The phase setting must be set to match the local network configuration.
OPTIONAL SETTINGS WHEN SELECTING THE ETHERTALK OPTIONS:
Setting the EtherTalk zone
Default = “*”
Note: the “*” means the default EtherTalk zone that is specified by the
EtherTalk router, if a router is in use.
This option sets the AppleTalk printer name.
Default = XEROX PRINTER
NOTE: These zone and printer name settings are set using the Xerox
8825/8830 Printer Manager Tool software. These optional settings may
be required by your network environment. Consult your network
administrator for the requirements for your specific configuration.
Path to EtherTalk options
Display
display
[ENTER], display
Selecting EtherTalk options
Press ENTER to display the first option which is ETHERTALK PORT
ENABLE (ON or OFF). The default is ON. Press the ENTER key to change
the mode. Press the NEXT key to select either ON or OFF, when the desired
mode is displayed press the ENTER key.
Press the NEXT key to go to EtherTalk PHASE set mode. Press the ENTER
to change the mode. Press the NEXT key to toggle through PHASE 1, or
PHASE 2. When the desired mode is displayed press the ENTER key.
EXITING ETHERTALK OPTIONS
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.