Xerox 8825 - Manual (Page 150)

8825/8830 Controller Setup Manual for Firmware 6.0 134
Problem Solving Status Codes
The following Controller Status Codes may appear on the 8825/8830
Printer Message Display. Follow the instructions in the table below
before calling for service.
Status Code or Message Operator Action Explanation
XEROX 8825/8830
INITIALIZING VERSION XXXX
None This is a normal message when the Controller is first
switched ON until it warms up and passes all power on tests.
XEROX 8825/8830
IDLE
None This is a normal message when the Controller is switched
ON, is warmed up, but is not printing.
XEROX 8825/8830
PROCESSING
None This is a normal message when the Controller is processing
prints.
XEROX 8825/8830
PAUSED
Press the ON-LINE key to return
to ON-LINE mode This is a normal message when the Controller is switched to
the OFF-LINE mode.
XEROX 8825/8830
ERROR: XXXXXX
Use the Xerox 8825/8830 System
Introduction to determine which
document to use to clear the
message. This is a normal message when the Controller or Printer has
a hard error condition that causes a printer shutdown.