Xerox 8825 - Manual (Page 72)

8825/8830 Controller Setup Manual for Firmware 6.0 56
Configuring the System Communication Defaults
(continued)
Setting The Serial Options (continued)
SELECTING THE SERIAL OPTIONS
Press the ENTER key to display PORT ENABLE. Press the ENTER key,
then the NEXT key to select either ON or OFF. When the desired mode is
displayed press the ENTER key.
Press the NEXT key followed by ENTER to change the Baud Rate. Press the
NEXT key to toggle through the Baud Rate Values (300, 600, 1200, 2400,
4800, 9600, 19200), and when the desired value is displayed, press the
ENTER key.
Press the NEXT key followed by ENTER to change the flow control setting.
Press the NEXT key to toggle through the XON/XOFF, RTS/CTS, BOTH, or
NONE menus, then when the desired menu is displayed, press the ENTER
key.
Press the NEXT key followed by ENTER to change the parity option. Press
the NEXT key to toggle through the ODD, EVEN, or NONE menus, then
when the desired menu is displayed, press the ENTER key.
EXITING THE SERIAL OPTIONS
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.