Safety information, Safety notes – Xerox 8825 User Manual
Page 3

8825/8830 Controller Setup Manual for Firmware 6.0
i
Safety Information
Safety Notes
Your Controller has been designed and tested to meet strict safety
requirements. These include safety agency examination and approval and
compliance with established environmental standards.
Please read the following instructions carefully before operating the
Controller and refer to them as needed to ensure the continued safe
operation of the product.
Follow all warnings and instructions marked on or supplied with the product.
Unplug the printer from the wall outlet before cleaning the exterior. Always
use materials specifically designated for the Xerox Controller. Other
materials may result in poor performance and could create a hazardous
situation.
Do not use aerosol cleaners. Follow the instructions in this operator manual
for the proper cleaning methods.
Never use supplies or cleaning materials for purposes other than those for
which they were intended. Keep all supplies and materials out of the reach
of children.
Do not use this product near water, wet locations, or outdoors.
This product is equipped with a three-wire, grounding-type plug (i.e., a plug
having a grounding pin). This plug will only fit into a grounding-type power
outlet. This is a safety feature. To avoid the risk of electric shock, contact
your electrician to replace the receptacle if you are unable to insert the plug
into the outlet.
Never use a ground adapter plug to connect the printer to a power source
that lacks a ground connection terminal.
This product should be operated from the type of power source indicated
on the marking label. If you are not sure of the type of power available,
consult your local power company.
The power supply cord is the disconnect device for this equipment.
Make sure that the installation is near the socket outlet and is easily
accessible.
Do not allow anything to rest on the power cord. Do not locate the
printer where someone can step on the cord.
Slots and openings in the cabinet and in the back and bottom of the printer
are provided for ventilation. To ensure reliable operation of the printer and to
protect it from overheating, these openings should never be placed near a
radiator or heat register. The printer should not be placed in a built-in
installation unless proper ventilation is provided.
Never push objects of any kind into the slots of the printer as they may touch
dangerous voltage points or short out parts, resulting in a risk of fire or
electric shock.
Never spill liquid of any kind on the printer.
Never remove any covers or guards that require a tool for removal. There
are no operator serviceable areas within these covers.
Never attempt any maintenance function that is not specified in this operator
manual.
Never defeat interlock switches. The Controller is designed to prevent
operator access to unsafe areas. Covers, guards, and interlock switches are
provided to ensure that the system will not operate with the covers opened.