Setting the image density (toner) option, Setting the image scale option, Image scale purpose – Xerox 8825 User Manual

Page 78: Setting the desired default mode for scaling dow, Images, Path to image scale option, Selecting image scale option, Image density purpose

8825/8830 Controller Setup Manual for Firmware 6.0

Configuring the Printer Setup Defaults (continued)

Setting The Image Density (Toner)
Option

Image Density Purpose

The purpose of this option is to set the toner density on the printed page.

The number (0) sets a minimum image density level, and the number (10)
sets a maximum image density level. When a new image density level is set,
the copies will immediately appear darker or lighter regardless of the toner
dispensing level set in the printer. This is because the Image Density (Toner)
setting is changing the image bar LED on time, and not the toner dispensing
rate.

SETTING THE TONER DENSITY.

Range: 0 to 10

Default: 5.

PATH TO IMAGE DENSITY OPTION

Display , press [ON-LINE], display , press [ENTER],
display , press [NEXT] until is displayed,
press [ENTER], display , press [NEXT] until DENSITY> is displayed.

SELECTING IMAGE DENSITY OPTION

Press the ENTER key to change the option. Input a number (0 - 10) at the
Keypad. With the desired value displayed, press the ENTER key.

EXITING IMAGE DENSITY OPTION

Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.