Xerox 8825 - Manual (Page 145)

8825/8830 Controller Setup Manual for Firmware 6.0 129
Configuring the System Administration Parameters
(continued)
Setting The Controller Configuration
Purpose
Beginning with Firmware version 6.0, this parameter is set by a Customer
Service Engineer at the time that new equipment is first set up at your site. If
you purchased a Digital Document System (printer and scanner), the
Customer Service Engineer will set this feature to DDS = ENABLED and the
Controller will attempt to find a scanner at power up to enable copy/scan
functionality. If you purchased a printer only, the Customer Service Engineer
will set this feature to DDS = DISABLED and the Controller will not attempt to
find a scanner at power up and copy/scan functionality will not be enabled. If
you have a Digital Document System, make sure that this parameter has
been set to DDS = ENABLED.
PATH TO SETTING THE CONTROLLER CONFIGURATION
At the Printer Control Panel when the display shows , press [ON-
LINE]. When the display shows , press [ENTER]. When the
display shows , press [NEXT] until ADMINISTRATION> is displayed. Press [ENTER] to display PASSWORD>. Press [ENTER] and, using the numeric keypad, input the
required “password.” Press [ENTER] again. If your password was valid,
will be displayed. Press [NEXT] until CONFIGURATION> is displayed and press [ENTER]. When (ENABLED or DISABLED)> is displayed, press [ENTER]. Use the [NEXT]
key to toggle between ENABLED and DISABLED. Press [ENTER] to confirm
your selection Press [EXIT] to escape the current menu. Press [ON-LINE] to
put the printer back on line.