Xerox 8825 - Manual (Page 92)

8825/8830 Controller Setup Manual for Firmware 6.0 76
Configuring the Printer Setup Defaults (continued)
Setting The Versatec Raw Raster
Emulation Options
Versatec Raw Raster Emulation Purpose
SELECTING THE DEFAULT RAW RASTER EMULATION DEVICE TO BE
USED
Range: 7222, 7224, 7225, 7236, 7422, 7424, 7425, 7436, 8222, 8224, 8236,
8510, 8524, 8524HR A, 8524HR I, 8536, 8536HR, 8624 A, 8624 I, 8624HR
A, 8624HR I, 8625, 8625HR, 8636, 8636HR, 8770-24, 8770-24I, 8770-36,
8825/8830, 8845, 8825/8830 SERVEWARE, 8830 EDMICS, or Custom.
Default: 8825/8830
SELECTING THE DEFAULT RAW RASTER CHARACTER ENCODING TO
BE USED
Range: EBCDIC or ASCII
Default: ASCII
The following options must be set only when selecting the Raw Raster
Custom mode.
SETTING THE DEFAULT RASTER BYTE PER LINE
Range: 10 - 3000
Default: 128
SETTING THE RASTER CHARACTERS PER LINE
Range: 10 - 2000
Default: 128
SELECTING THE DEVICE RESOLUTION
Range: 100, 200, 300, or 400
Default: 100
PATH TO VERSATEC RAW RASTER EMULATION OPTIONS
Display , press [ON-LINE], display , press [ENTER],
display , press [NEXT] until is displayed,
press [ENTER], display , press [NEXT] until
is displayed, press [ENTER], display , press
[NEXT] until is displayed, press [ENTER], display RASTER EMULATION>
SELECTING THE VERSATEC RAW RASTER EMULATION OPTIONS
Press the ENTER key to change the Raw Raster device option. Press the
NEXT key to toggle through the VERSATEC DEVICE choices. When the
desired choice is displayed, press the ENTER key.
Custom requires three values to be input. Follow the screen instructions and
input the: Device resolution, Device Bytes/Line, and Device Characters/Line
values.
Press the NEXT key then the ENTER key to change the Character Set. Press
the NEXT key to toggle the choices, EBCDIC or ASCII. When the desired
choice is displayed press the ENTER key.
EXITING VERSATEC RAW RASTER EMULATION OPTIONS
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.