Xerox 8825 - Manual (Page 127)

8825/8830 Controller Setup Manual for Firmware 6.0 111
Configuring the Printer Processing Defaults (continued)
Setting the Set Page Scaling Option
Set Page Scaling Option Purpose
Sets the printer for scaling each page for best fit to the available media, or to
a specified scaling ratio.
Range: NUMERIC (10%- 999%), or AUTO
Default: 100%
This is applied in the following priority order:
• Instructions embedded within a print job’s native data format are applied
with highest priority.
• Parameters specified through job control instructions (such as HP-PJL)
associated with the print job are applied next.
• Printer default parameters are applied to all remaining unspecified
parameters.
PATH TO THE SET PAGE SCALING OPTION
Display , press [ON-LINE], display , press [ENTER],
display , press [NEXT] until is
displayed, press [ENTER], display , press
[NEXT] until is displayed.
SELECTING THE SET PAGE SCALING OPTION
Press the ENTER key to change the option. Press the NEXT key to toggle
through the selections AUTO or NUMERIC. When the desired selection is
displayed, press the ENTER key. If NUMERIC is chosen, enter the desired
value at the Keypad (10 % - 999 %) when prompted, and press ENTER to
confirm.
Note: The Page Scaling AUTO selection is not allowed when Media Size
ANY is selected.
EXITING THE SET PAGE SCALING OPTION
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.