Xerox 8825 - Manual (Page 36)

8825/8830 Controller Setup Manual for Firmware 6.0 20
Controller Overview (continued)
Preparing The Serial Ports
The Host Serial Port
This port requires a null modem serial cable to be connected from the
Controller host serial port to the workstation serial port. It is necessary to
use the appropriate software drivers or system commands to send jobs to
the Controller.
The Controller serial host interface port supports user-definable Baud Rate,
Flow Control, and Parity.
Enable Controller Serial Port
Use the Setup I/O Ports menu of the Printer Control Panel to enable the
Serial port and select the Baud Rate, Flow Control, and Parity to match those
set at the workstation.
Network Protocols Supported
Does not apply to the serial port.
Software Supported
WINDOWS 95/98 PLATFORM:
• HP-GL/2/RTL Print Driver
• ADI Driver for AutoCAD R13/14
• HDI Driver for AutoCAD 2000 and 2000i
• PostScript PPD System Print Driver
• Document Submission Tool (part of AccXES Client Tools)
WINDOWS NT 4.0 & 2000 PLATFORMS:
• HP-GL/2/RTL Print Driver
• ADI Driver for AutoCAD R13/14
• HDI Driver for AutoCAD 2000 and 2000i
• PostScript PPD System Print Driver
• Document Submission Tool (part of AccXES Client Tools)
UNIX PLATFORM:
Does not apply to the serial port.