beautypg.com

Setting the netbeui option (legacy 3003-xtp nic), Selecting ethertalk options, Exiting ethertalk options – Xerox 8825 User Manual

Page 67: Path to the netbeui option

background image

8825/8830 Controller Setup Manual for Firmware 6.0

51

Configuring the System Communication Defaults
(continued)

Setting The NETBEUI option
(Legacy 3003-XTP NIC)

The NETBEUI Purpose

The purpose of this option is to set the multiprotocol 3003-XTP NIC to be
enabled to use the NETBEUI protocol. The 10/100 Ethernet card/port does
not support the NETBEUI protocol. All Controllers now use an optional,
external Ethernet Adapter to support NetBEUI.

This option enables the 3003-XTP NIC to use the NETBEUI protocol:

Range: ON, or OFF

Default: ON

Depending on your network environment the NETBEUI workgroup name may
have to be changed from the factory default of “Workgroup”. Use the Xerox
8825/8830 Printer Manager Tool software to change the workgroup name.
Refer to the Xerox 8825/8830 Printer Manager Tool Manual for the
procedure.

Consult your network administrator for local network requirements. The
Xerox 8825/8830 Network Administrator Guide also contains procedures for
communicating with the printer using the NETBEUI protocol.

Path to the NETBEUI option

Display , press [ON-LINE], display , press [ENTER],
display , press [NEXT], display , press
[ENTER], display , press [NEXT] until is displayed.

Selecting the NETBEUI option

The first option is NETBEUI Port Enable (ON or OFF). The default is ON.
Press the ENTER key to change the mode. Press the NEXT key to select
either ON or OFF, when the desired mode is displayed press the ENTER key.

EXITING THE NETBEUI OPTION

Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.