Xerox 8825 - Manual (Page 123)

8825/8830 Controller Setup Manual for Firmware 6.0 107
Configuring the Printer Processing Defaults (continued)
Setting the Media Source Option
Media Source Option Purpose
This option sets the default roll position to be used for all jobs.
Range: ROLL1, ROLL2, ROLL3, MANUAL FD, or AUTO
Default: AUTO
This image placement parameter is applied in the following priority order:
• Instructions embedded within a print job’s native data format are applied
with highest priority.
• Parameters specified through job control instructions (such as HP-PJL)
associated with the print job are applied next.
• Printer default parameters are applied to all remaining unspecified
parameters.
Note: If a job is sent to the printer and the desired roll size is not installed, the
user will be prompted to load the correct size media (provided that the
bond/vellum/film mismatch modes have been set to QUERY).
PATH TO MEDIA SOURCE SET OPTION
Display , press [ON-LINE], display , press [ENTER],
display , press [NEXT] until is
displayed, press [ENTER], display , press
[NEXT] until is displayed.
SELECTING THE MEDIA SOURCE OPTION
Press the ENTER key to change the option. Press the NEXT key to toggle
through the selections, and when the desired selection is displayed, press the
ENTER key.
EXITING THE MEDIA SOURCE OPTION
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.