Controller specifications (n5t/cng product code), Physical characteristics, Electrical requirements – Xerox 8825 User Manual
Page 31: Agency approvals, Hardware specifications, Controller overview, Setting the controller port defaults, Setting up the ten custom print job defaults

8825/8830 Controller Setup Manual for Firmware 6.0
15
Controller Overview
Controller Specifications
(N5T/CNG Product Code)
Physical Characteristics
The Controller is attached to the side panel of the 8830 Printer as an
embedded device.
Electrical Requirements
100 - 250 VAC auto-ranging power supply.
Agency Approvals
Safety:
UL 1950, CA22.2 No. 950 (CUL), EN 60950 (CE Mark)
EMC:
CE Mark, FCC Class A, Canada Radio Interference Regulations
Class A, VCCI Class 1
Hardware Specifications
CPU
Power PC 740 operating at 200 MHz clock speed.
ROM/RAM For both Standalone Printer and Printer with Scanner
Configurations
• Non-PostScript - 4MB Flash ROM (N5T only) and 64MB
SDRAM DIMM
• PostScript - 8MB Flash ROM (N5T only) and 64MB SDRAM
DIMM
• Maximum RAM is 192MB
Floppy
1.44 Mbytes (standard 3.5 inch)
Hard disk
Ultra SCSI, 7200 rpm internal hard disk drive (optional on N5T,
standard on CNG)
Note: The hard drive is required for installation of 6.0 firmware.