Xerox 8825 - Manual (Page 114)

8825/8830 Controller Setup Manual for Firmware 6.0 98
Configuring the Printer Processing Defaults (continued)
Setting the Justification X Set Option
Purpose of Justification X Option
This option specifies the left margin position of the printed image on the
page. The option may be specified in absolute terms (millimeters) or relative
(center, left, right) when the output print is not a specific size (e.g. ANSI D,
ARCH C, ISO B2, etc.). For roll-fed media, the x axis is the same as the feed
direction of the media. For sheet-fed media, the x axis is on the long edge of
the paper.
Range: NUMERIC (0 - 2540 MM), LEFT, RIGHT, or CENTER
Default: LEFT
This parameter sets the justification of the image on the page. Justification
may be specified in absolute distances or using one of the relative distances
{LEFT, CENTER, RIGHT} for the X direction and {TOP, CENTER, BOTTOM}
for the Y direction.
There are several possible scenarios for handling the case where the
justification is specified for X and Y in absolute distance. In the case where
the image size is fixed and the physical paper size is fixed, then the image is
justified with the specified X and Y dimensions from the upper left corner of
the page. In other words, the image is justified relative to the corner of the
paper.
If the image size or paper size adaptively varies in one or both of the X and Y
directions, then for the varying dimensions, the justification specification acts
as a margin specification: the varying dimension will be adjusted to allow the
specified justification distance on either side of the image relative to the
paper. Image size adaptively varies when auto-scaling is applied. Physical
paper size varies when a roll is specified (as in long plot), and the length is
cut to fit the image length.
If justification is set to one of LEFT, TOP, RIGHT, or BOTTOM, the image is
justified in the appropriate manner on the physical page.
If justification is set to CENTER, then the image will be justified in the center
of the printable page area.
PATH TO THE JUSTIFICATION X OPTION
Display , press [ON-LINE], display , press [ENTER],
display , press [NEXT] until is
displayed, press [ENTER], display , press
[NEXT] until is displayed.
SELECTING THE JUSTIFICATION X OPTION
Press the ENTER key to change the option. Press the NEXT key to toggle
through the selections LEFT, CENTER, RIGHT, or NUMERIC. When the
desired selection is displayed, press the ENTER key. If NUMERIC is chosen,
enter the desired value on the Keypad (0 -2540 MM) when prompted.
EXITING THE JUSTIFICATION X OPTION
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.