Raster stamp rotate set option, Selecting the right margin option, Exiting the bottom margin option – Xerox 8825 User Manual

Page 133: Setting the oversize margin option, Oversize margin purpose, Path to oversize margin option, Raster stamp rotate set option purpose

8825/8830 Controller Setup Manual for Firmware 6.0

117

Configuring the Printer Processing Defaults (continued)

Raster Stamp Rotate Set Option

Raster Stamp Rotate Set Option Purpose

This option sets the rotation of the raster stamp before it is applied to the
page.

Range: 0, 90, 180, or 270 degrees

Default: 0 degrees

PATH TO THE RASTER STAMP ROTATE SET OPTION

Display , press [ON-LINE], display , press [ENTER],
display , press [NEXT] until is
displayed, press [ENTER], display , press
[NEXT] until is displayed, press ENTER, press NEXT
until is displayed.

SELECTING THE RASTER STAMP ROTATE SET OPTION

Press the ENTER key, then the NEXT key, to change the option. Press
ENTER to confirm.

EXITING THE RASTER STAMP ROTATE SET OPTION

Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.