beautypg.com

Preparing the host ultra scsi port, Ultra scsi port (host), Enable controller scsi port – Xerox 8825 User Manual

Page 42: Network protocols supported, Software supported, Data formats supported, Scsi cable description, Ultra scsi connector pin outs (host), Preparing the 3003-xtp nic ethernet port, Ethernet port (optional nic for 8830)

background image

8825/8830 Controller Setup Manual for Firmware 6.0

26

Controller Overview (continued)

Preparing the Host Ultra SCSI Port

Ultra SCSI Port (Host)

To use this port your workstation must have a SCSI interface card and
appropriate software installed and operating. An optional card is also
required for use with the 8825 EV4 Controller.

Enable Controller SCSI Port

Use the Setup I/O Ports menu of the Printer Control Panel to enable the port
and set a device number compatible with your workstation. By default, the
host SCSI port bus termination is enabled.

Network Protocols Supported

Does not apply to the SCSI-2 port.

Software Supported

• ServeWare Version 2.42 or later.
• VGS (in Xerox 150 Emulation Mode)

Data Formats Supported

• Xerox 150 Emulation

• Versatec Raw Raster

• VDS

• VCGL

SCSI Cable Description

The SCSI-2 cable must not exceed a maximum length of 9.75 feet (3
meters).

Ultra SCSI Connector Pin Outs (host)

Pin
Numbe
r

Signal
Name

Pin
Numbe
r

Signal
Name

Pin
Numbe
r

Signal
Name

1

GROUND

18

GROUND

35

GROUND

2

GROUND

19

GROUND

36

GROUND

3

GROUND

20

GROUND

37

No Connect

4

GROUND

21

GROUND

38

SATRMPW
R

5

GROUND

22

GROUND

39

No Connect

6

GROUND

23

GROUND

40

GROUND

7

GROUND

24

GROUND

41

SAATN*

8

GROUND

25

GROUND

42

GROUND

9

GROUND

26

SADB0*

43

SABSY*

10

GROUND

27

SADB1*

44

SAACK*

11

GROUND

28

SADB2*

45

SARST*

12

No Connect

29

SADB3*

46

SAMSG*

13

No Connect

30

SADB4*

47

SASEL*

14

No Connect

31

SADB5*

48

SACD*

15

GROUND

32

SADB6*

49

SAREQ*

16

GROUND

33

SADB7*

50

SAIO*

17

GROUND

34

SADBP*