Xerox 96MX - Manual (Page 417)

PDL COMMAND QUICK REFERENCE
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE B-3
ac:CRITERIA ac:CRITERIA CHANGE = (offset, length, NE, LAST)
CONSTANT = ( offset, length, {EQ | NE}, tab-id)
ac:CRITERIA LINENUM = (int, count)
—
—
ALL LINES
END END; —
EXPORT SEPARATORS = {FIRST | LAST | [,D]) | (BOTH[,D]) | NONE}
SNUMBER = ( lnum,cnum,findex)
SPLIT = {NOW | ( min,max) | OFF}
SRECOVER = {PAGE | SEGMENT | ASK | DEVICE}
STIMING = {(INTERVAL,sec) | (DELAY,sec) | (INTERVAL,sec
,DELAY,sec)}
NONE
—
—
PAGE
—
IDEN OFFSET = value
OPRINFO = {YES | NO}
PREFIX = sc
SKIP = value
0
NO
—
1
ac:IDR (4850
LPS only) IDR ICATALOG = ink-catalog-name
IDR ILIST = {’ ink-name’ | (’ ink-name’,[,’ink-name’],[,...])}
IDR PALETTE = ’ palette-name’
DFAULT
—
DFAULT
JDE [INCLUDE = ( catalog-id
1
[, catalog-id
2
][,...])] —
JDL JDL = jdl-id —
ac:JOB [INCLUDE = ( catalog-id
1
[, catalog-id
2
][,...])] —
LINE LINE DATA = ( pdo, length)
LINE FCB = {IGNORE | PROCESS}
LINE FONTINDEX = { offset | offset ([,init-val][,bit-opt]) | NONE}
LINE INKINDEX = { offset | offset ([,init-val][,bit-opt]) | NONE}
LINE MARGIN = { value | ( value,value-type)}
LINE OVERPRINT = ( over-opt, disp)
LINE PCC = ( offset, trans-type)
LINE PCCTYPE = pcc-name
LINE UCSB = {IGNORE | PROCESS}
LINE VFU = { vfu-id | NONE}
offline=1,134;
online=0,150
PROCESS
NONE
NONE
1,POS
PRINT,NODISP
0,NOTRAN
offline=ANSI
online=IBM3211
PROCESS
NONE
MESSAGE MESSAGE ITEXT = { sc | (sc,passnum) | NONE}
MESSAGE OTEXT = { sc | (sc[,passnum])[,WAIT] |
sc[,END][,WAIT] | NONE}
NONE
NONE
Table B-2. PDL command quick reference (continued)
Command Syntax Default