Xerox 96MX - Manual (Page 387)

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE 8-59
TMODE
This parameter specifies process direction measurement for
determining default pitch mode.
Syntax TMODE = option(s)
Options Table 8-57 lists the parameter option(s) and definition(s).
TOF
This parameter specifies the top-of-form line number. It takes effect
at the next record following a DJDE END. The value parameter is
defined the same as in the VFU command as defined in the chapter
"Print format commands."
Syntax TOF = option(s)
Options Table 8-58 lists the parameter option(s) and definition(s).
Table 8-57. TMODE parameter option(s) and definition(s)
Option(s) Definition(s)
( width [,width
unit])
This option has the following components:
• width
The process direction measurement that
determines the default pitch mode.
•
width unit
Can be IN, CM, DOTS, or XDOTS. The default
is IN.
Width values can range from the 7-inch
equivalent to the 17-inch equivalent.
Table 8-58. TOF parameter option(s) and definition(s)
Option(s) Definition(s)
value Specifies the number of lines from the top of the
output page to the first print line on the page (top of
form). The top-of-form specification is independent of
channel assignments. It should be greater than or
equal to 1 and less than or equal to the smallest line
number assigned to a channel.
The default is 1.