Xerox 96MX - Manual (Page 375)

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE 8-47
PMODE
This parameter specifies the printing mode for each page.
LANDSCAPE indicates that printing is to be parallel to the long edge
of paper. PORTRAIT indicates that printing is to be parallel to the
narrow edge of paper. If PMODE is changed through a DJDE
command, the BEGIN command should be respecified (even if the
same horizontal and vertical position has been specified in the
previous BEGIN parameter).
Syntax PMODE = option(s)
Options Table 8-42 lists the parameter option(s) and definition(s).
RFORM
This parameter specifies a form to be printed with all RTEXT pages.
It takes effect on the next RTEXT page. The parameters are the
same as for the ROUTE command defined in the chapter "Print
format commands."
Syntax RFORM = option(s)
Options Table 8-43 lists the parameter option(s) and definition(s).
Table 8-42. PMODE parameter option(s) and definition(s)
Option(s) Definition(s)
LANDSCAPE Indicates that printing is to be parallel to the long
edge of paper.
PORTRAIT Indicates that printing is to be parallel to the narrow
edge of paper.
Table 8-43. RFORM parameter option(s) and definition(s)
Option(s) Definition(s)
form-id This is the name of a file cataloged in the FRM
directory. It is created by compiling a file of forms
source commands, called a JSL, with the FDL
compiler. (Refer to the
Xerox DocuPrint 96/
DocuPrint 96MX LPS Forms Creation Guide.) The
RFORM parameter is not allowed in a ROUTE
command which is being defined as a cataloged file
but is specified in the ROUTE command in the JSL
invoking the cataloged RTEXT file. Refer to the
“Cataloged RTEXT files” section in this chapter for
further details.
NONE Specifies that no form is to be printed.
The default is NONE.