Xerox 96MX User Manual
Page 388

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
8-60
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE
TRANS
This parameter specifies whether or not transparencies are used in
the print job.
Syntax
TRANS =
option(s)
Options
Table 8-59 lists the parameter option(s) and definition(s).
XSHIFT
This parameter specifies whether the image of the form and data on
a page is to be shifted, and if so, by what values. This parameter is
used to shift the image of the data for two-hole paper, binding,
finishing, and edgemarking. XSHIFT allows shifting in the x-direction
for short-edge binding.
Syntax
XSHIFT =
option(s)
Options
Table 8-60 lists the parameter option(s) and definition(s).
Table 8-59.
TRANS parameter option(s) and definition(s)
Option(s)
Definition(s)
YES
Specifies that transparencies are used in the print
job.
NO
Specifies that transparencies are not used in the print
job.
Table 8-60.
XSHIFT parameter option(s) and definition(s)
Option(s)
Definition(s)
NO
Specifies that no shift occurs.
value
An integer that specifies a shift amount on the front
and back side. The shift is in the x-direction and each
dot is 1/300 of an inch. The allowable range is 75 to
-75.