Xerox 96MX User Manual
Page 371

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE
8-43
MODIFY
This parameter specifies the copy modification entry (CME) to be
used in report processing. It takes effect at the next logical physical
page boundary. A cme-id refers to a file which is separately
cataloged in the CME directory. Refer to the “CME” section in the
chapter "Print format commands" for further information. The
parameters are the same as those in the OUTPUT command defined
in the chapter "Print format commands."
Syntax
MODIFY =
option(s)
Options
Table 8-38 lists the parameter option(s) and definition(s).
Table 8-38.
MODIFY parameter option(s) and definition(s)
Option(s)
Definition(s)
(
cme-id,[init]
[,
copies])NONE
This option has the following components:
•
cme-id
The command identifier of a CME. The CME
may be coded within a JSL or coded and
cataloged separately for use by several JSLs.
Any CME invoked by a DJDE must be
cataloged separately (refer to the “Cataloged
CMEs” section in this chapter for further
information). If the CME is within the JSL, it
must precede a reference to its identifier by the
MODIFY parameter. Details on CME usage and
syntax are discussed in the “CME” section of
the "Print format commands" chapter.
•
init
Specifies the initial ply (pass) to which the
associated CME is to be applied.
•
copies
Specifies the number of plies (passes) on which
to apply the CME. If copies is not specified, then
the CME applies to all copies beginning with the
copy number specified by init.
•
NONE
Specifies that data are processed without
modification.
The default is NONE.