Xerox 96MX - Manual (Page 352)

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
8-24 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE
BOF
This parameter specifies the bottom-of-form line number. It takes
effect at the next record following a DJDE END parameter. A value is
defined the dame as for VFU BOF in the chapter "Print format
commands."
Syntax BOF = option(s)
Options Table 8-15 lists the parameter option(s) and definition(s).
Considerations If bottom-of-form (BOF) is altered by DJDE to a line number smaller
than the current line from which the DJDE was processed, input
effects an immediate page transition. If carriage control action to
perform at BOF is specified as OVR (the default), input spaces from
TOF a number of lines equal to the difference between its location at
DJDE and the new BOF. Refer to the PCC ASSIGN command in
chapter 5 regarding alternate BOF parameters.
Parameter rules
Note the following rules:
•
All parameters have the form
keyword = value
• values must be specified. A value may be a keyword described
as listed in table 8-16.
•
Parameters are separated by a comma.
• values cannot have commas embedded.
•
White space within a parameter is ignored if it immediately
precedes or follows the ”=” sign.
Table 8-15. BOF parameter option(s) and definition(s)
Option(s) Definition(s)
value Specifies the number of lines from the top of the
output page to the last print line on the page (bottom
of form).
Table 8-16. Value(s) and definition(s)
value(s) Definition(s)
xxx Alphanumeric text, including spaces. Case sensitivity
is retained.
nnn Numeric text, including one optional decimal point.
Maximum of two digits after the decimal point.
sss Numeric text, no decimal points.
yy-mm-dd Numeric text describing year, month, an d day. Each
pair of characters is separated by a dash. Eight
characters in all are required.