beautypg.com

Xerox 96MX User Manual

Page 390

background image

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)

8-62

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE

SNUMBER

If the system encounters a valid SNUMBER dynamic job
descriptor entry after an incorrect EXPORT command
SNUMBER parameter had been specified, unpredictable
results may occur.

SNUMBER as a DJDE may only be used to change current line
or column numbers and fontindex values that are specified in
the SNUMBER parameter of the EXPORT command used in
the JDL. The DJDE SNUMBER may only enable segment
sequence numbering if it is invoked with the SEPARATORS
DJDE.

Ending a segment

A segment may be ended by a DJDE under any of these
conditions:

SEPARATORS is specified in a DJDE

The system encounters a SPLIT=NOW dynamic job
descriptor entry

The system encounters a SPLIT=OFF dynamic job
descriptor entry.

Using a new separator page

You may use a new separator page by specifying it as a DJDE.

Resetting the segment number

You may set a new segment number after the current one is
terminated. This is accomplished when the system encounters
a series of two DJDEs: SPLIT=OFF followed by
SPLIT=(min,max).