Xerox 96MX - Manual (Page 317)

USING LOGICAL PROCESSING
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE 7-37
— If DELIMITER=YES is specified, a record that satisfies the
TEST criteria of a selected JDE or JDL results in an end of
report normally. However, it prints at the start of the
subsequent report unless it also satisfies the TEST (or
DJDE) criteria of the starting JDE or JDL.
— If RSTACK is specified in the JDE or JDL of the START
command but not in the selected JDE or JDL, RSTACK
processing is suspended until end of report is triggered by
BANNER page detection.
— If ACCTINFO is specified in the JDE or JDL of the START
command, the ACCTINFO parameter cannot be changed
or deleted in a selected JDE or JDL (even if RSTACK is
suspended).
— If ACCTINFO is not specified in the JDE or JDL of the
START command, it can be invoked in a selected JDE or
JDL. The first record after the selected JDE takes effect is
then printed as the ACCTINFO field.
The following sections describe the syntax of the command
parameters and explanations of the parameter options.
ACCTINFO
This parameter specifies that a subfield of the first record is being
printed on the accounting page at the end of the report. If
DELIMITER=YES is also coded, the subfield is from the first delimiter
record of the report. For DELIMITER=NO the subfield is from the first
data record.
Syntax RSTACK ACCTINFO = option(s)
Options Table 7-24 lists the parameter option(s) and definition(s).
There is no default.
Table 7-24. ACCTINFO parameter option(s) and definition(s)
Option(s) Definition(s)
( offset, length) This option has the following components:
•
offset
Specified in bytes (relative to zero) from the
start of the user’s portion of the record to the
subfield within the record.
• length
The number of bytes in the subfield (1 to 64).