Xerox 96MX - Manual (Page 367)

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE 8-39
The parameters T, H, and n/d are not order dependent. They may be
coded as needed without extra position holding commas.
If the UN parameter is used to define position, the UNITS parameter
must precede this command in the OUTPUT command.
Example IMAGE=(IMG1, 3, 2), END;
INVERT
This parameter specifies that the following pages are to be inverted.
When specified in a DJDE data stream (page oriented), this feature
allows the Xerox DocuPrint 96/DocuPrint 96MX LPS to invert the
image on a physical page by 180 degrees.
Syntax INVERT = option(s)
Options Table 8-32 lists the parameter option(s) and definition(s).
Table 8-32. INVERT parameter option(s) and definition(s)
Option(s) Definition(s)
FRONT Specifies page inversion on front sides.
BACK Specifies page inversion on back sides.
BOTH Specifies page inversion on both front and back
sides.
NONE Specifies turning page inversion off.