Xerox 96MX - Manual (Page 406)

USING GRAPHICS
9-8 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE
PDL command and DJDE options for graphics
Several PDL commands are available for graphic handling. These
include four job descriptor entry (JDE) OUTPUT commands and six
dynamic job descriptor entries (DJDEs).
Tables 9-1 and 9-2 summarize these commands.
The DJDEs are record oriented because they take effect
immediately. For example, the ALTER, CANCEL, and IMAGE
commands may appear anywhere on the page and are applied to the
page on which they occur. The GRAPHIC, BATCH, and SAVE DJDE
commands also take effect immediately.
Page-oriented DJDEs applied to the next page must not precede
page interleaved graphics to be applied to the current page.
Table 9-1 lists the OUTPUT command parameters and functions for
graphics
Table 9-2 lists the DJDE definitions for graphics
Refer to the chapter "Specifying dynamic job descriptor entries
(DJDEs)" for more information on DJDEs.
Table 9-1. OUTPUT command parameters and functions for
graphics
Option(s) Definition(s)
GRAPHICS Specifies graphics may be used in current job.
IMAGE Specifies initial scaling and positioning parameters
for batch mode.
PURGE Specifies default disposition of document interleaved
graphics.
UNITS Specifies user-selected units for positioning
graphics.
Table 9-2. OUTPUT command parameters and functions for
graphics
Option(s) Definition(s)
ALTER Specifies new imaging parameters for graphics
previously referenced using HOLD statement.
BATCH Marks beginning and end of online batch mode
graphic data.
CANCEL Terminates option of the GRAPHICS DJDE.
GRAPHIC Precedes interleaved graphic in data stream.
IMAGE Specifies name, scaling, and positioning of a graphic
printed.
SAVE Identifies document interleaved graphics not to be
deleted or purged.