Xerox 96MX - Manual (Page 342)

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
8-14 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE
DJDE operator information pages
The changes to the JDE, specified in the DJDE, are incorporated
when END parameter is encountered. The changes begin on the
next record or page following the last DJDE record.
The specification OPRINFO=YES in the JDE ensures that the DJDE
records are printed and sent to the tray at the next page transition
after an END parameter. The DJDE records are printed on a
separate page from the report data. However, no page formatting
occurs and DJDEs on one long record are truncated at the end of the
physical page boundary. They are printed and delivered to the tray
regardless of the OPRINFO parameter if the DJDE contains an error.
Comments in the DJDE may be used for operator notification or
output routing instructions in conjunction with the OPRINFO
parameter.
In duplex processing, DJDE records are printed as duplex pages with
a blank page on the back (and are counted on the accounting sheet).
If a DJDE is applied at the transition to the back side of a duplex page
and OPRINFO=YES, the DJDEs are printed following the back side
page. A row of asterisks (*****) appears on the DJDE page following
the parameters whose printing is so delayed.
The message:
***MISSING END COMMAND OR MISSING PAGE BOUNDARY
is automatically printed on an OPRINFO page at the end of a report if:
• No END parameter is found in the DJDE.
•
No complete page boundary was found before the end of the
report, that is, at the end of report there were some DJDEs that
had not yet been applied.