Xerox 96MX - Manual (Page 107)

SPECIFYING INPUT PARAMETERS
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE 4-15
Considerations You do not have to specify consecutive byte values. For example,
you can code the following command as a single command:
ASSIGN=(X’60’,SP1), ASSIGN=(X’61’,SP2),
ASSIGN=(X’62’,SP3);
The single command is:
ASSIGN=(X’60’,SP1,SP2,SP3));
If, when the LINE command byte translation is specified, the PCC
control byte is translated into LPS-standard EBCDIC before being
applied. You must therefore specify the byte option of the ASSIGN
parameter as an EBCDIC translation of the PCC byte. An example is
X’F1’ or ’1’.