Xerox 96MX User Manual
Page 102

SPECIFYING INPUT PARAMETERS
4-10
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE
DEFAULT
This parameter specifies a base code from which code assignment
exceptions can be made. The base code is specified by a code-type;
the exceptions are specified using the ASSIGN parameter.
Syntax
CODE DEFAULT =
option(s)
Options
Table 4-15 lists the parameter option(s) and definition(s).
Point to note
Multiple user-defined code translation tables are allowed, but only
one may be without a command identifier. The corresponding CODE
and LCODE parameters of the VOLUME command are used to
reference each user-created code table by a command identifier. The
USER option of the CODE and LCODE parameters of the VOLUME
command are used to reference a user-defined code translation table
in which no command identifier is coded.
Table 4-15.
DEFAULT parameter option(s) and definition(s)
Option(s)
Definition(s)
code-type
This option can be one the following:
•
EBCDIC
•
ASCII
•
BCD
•
PEBCDIC
•
H2BCD
•
H6BCD
•
IBMBCD
•
value
A
value is a one-byte hexadecimal, octal, or
alpha constant. If a value is specified, all inputs
are coded to the specified
value.
The DEFAULT parameter must be coded prior to any
ASSIGN parameter for the assignment exceptions to
come into effect. A DEFAULT parameter following
any defined corresponding ASSIGN input or output
parameter options causes this correspondence to be
replaced by the DEFAULT parameter.
The default is EBCDIC.