Xerox 96MX - Manual (Page 343)

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE 8-15
Job parameter modification restrictions
To process a DJDE, the system has already been required to
process data up to the recognition and interpretation of the DJDE
itself. This requires that the basic description of the input source must
have been correct prior to the application of the DJDE. Thus, the
description of the input source cannot be changed through DJDE,
either by accident or by intent. The system does not allow these basic
parameters to be changed through the DJDE parameter JDE (as
defined in table 8-4). The JDE specified by JDE=DJDE is referred to
as a selected JDE. The parameters which cannot be changed
through a selected JDE are listed in table 8-8.
Changing the online BANNER offset criteria or VOLUME command
OPTIMIZE parameter in a selected JDE causes unpredictable results
and should not be attempted.
Table 8-8. Parameters which cannot be changed through a
JDE
Command Parameter(s)
VOLUME HOST
LABEL
UNPACK
OUTPUT OFFSET
IDEN All parameters
BLOCK All parameters
RECORD All parameters
BANNER All parameters