Xerox 96MX - Manual (Page 177)

PRINT FORMAT COMMANDS
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE 6-3
ERROR
This parameter specifies the required system response to abnormal
conditions detected in input while processing or compiling DJDEs.
Syntax ABNORMAL ERROR = option(s)
Options Table 6-3 lists the parameter option(s) and definition(s).
Considerations The CONTINUE and ABORT parameters are referred to as non-stop
modes. The STOP parameter is the stop mode. Any abnormal
condition detected, such as syntax error in DJDE specifications,
missing file referred to by a DJDE, RTEXT error, or GRAPHIC error
in either mode results in an appropriate error message being
displayed. In addition, during the stop mode, the displayed error
message is followed by a DJDE error message:
OS2006 ENTER CONTINUE I OR ABORT I
If abnormal conditions are detected while processing or compiling
DJDEs, the DJDE parameter set containing the offending entry is set
up to print on the OPRINFO page and an error message is displayed.
Errors detected while processing RTEXT data are not reported to the
user. The graphics processing errors are reported separately on the
graphics exception page printed at the end of the report.
Table 6-3. ERROR parameter option(s) and definition(s)
Option(s) Definition(s)
CONTINUE Displays the normal system message defining the
abnormal condition and continues processing the
report without applying the offending DJDE
parameter and without offering the operator the
parameter of continuing or aborting the job.
ABORT Displays the message for the abnormal condition and
aborts only the report it is processing (not the entire
job) without offering the operator the parameter of
continuing or aborting the job.
STOP The default for this parameter and indicates that the
system stop processing the report and wait for the
operator to respond with a CONTINUE or ABORT
command.
The default is STOP.