Xerox 96MX - Manual (Page 267)

PRINT FORMAT COMMANDS
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE 6-93
FONTS
This parameter specifies the fonts to be used in printing variable
input data and CME data.
Syntax ac:PDE FONTS = option(s)
Options Table 6-76 lists the parameter option(s) and definition(s).
There is no default for LPI for s
1
.
Considerations If an override line spacing value is specified, lines printed using the
font cause the indicated line spacing to be performed after the line
using the font. If different fonts are used on the same print line, the
line spacing value specified for the font of the largest character in the
line is used to determine the position of the next print line.
PMODE
This parameter specifies the printing mode for each physical sheet.
Syntax ac:PDE PMODE = option(s)
Options Table 6-77 lists the parameter option(s) and definition(s).
Table 6-76. FONTS parameter option(s) and definition(s)
Option(s) Definition(s)
( f
1
[, f
2
][,...]) |
(( f
1
, s
1
)[,( f
2
, s
2
)][,...]) |
(( f
1
, s
1
,[LPI | XDOTS |
DOTS])[,( f
2
, s
2
,[LPI |
XDOTS | DOTS])][,...])
This option has the following components:
• f
Specifies a one-to-six alphanumeric character
identifier (consisting of at least one letter)
corresponding to a font cataloged on the
system disk (up to 128 fonts can be used with
the font indexing capability).
• s
Specifies an optional override line-spacing
value defined by either the print lines per inch
(LPI) or the dots per print line (DOTS) to be
associated with the font. Maximum value for si
is 30 LPI; minimum value is 10 dots. If unit (LPI
or DOTS) is not specified, LPI is assumed by
default.
Table 6-77. PMODE parameter option(s) and definition(s)
Option(s) Definition(s)
LANDSCAPE Indicates that printing is to be parallel to the long
edge of paper.
The default is LANDSCAPE.
PORTRAIT Indicates that printing is to be parallel to the narrow
edge of paper.