Xerox 96MX - Manual (Page 350)

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
8-22 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE
BEGIN
This parameter specifies the location of the starting print line of a
logical page for graphics. The vpos parameter specifies the vertical
position of the first character of the first print line on the logical page.
It may be specified in inches (IN) or centimeters (CM). The default is
inches.
Syntax BEGIN = option(s)
Options Table 8-13 lists the parameter option(s) and definition(s).
In specifying the location of the beginning of a print line on the logical
page, measurement is performed by viewing the page in the mode
(landscape or portrait) in which it is to be printed. There may be more
than one logical page per physical page; these are defined by the use
of multiple BEGIN parameters. If no BEGIN parameter is specified,
then the default is FMT1.
Table 8-13. BEGIN parameter option(s) and definition(s)
Option(s) Definition(s)
vpos Specifies a decimal number with up to three digits to
the right of the decimal point, for example, 0.563IN
and 2.35CM are all legal specifications.
hpos Specifies the horizontal position of the first character
of the first print line on the logical page (in IN or CM
as for vpos). All specifications are rounded to the
nearest dot (1/300 of an inch) for positioning of the
logical page.