beautypg.com

Xerox 96MX User Manual

Page 361

background image

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE

8-33

FONTS

This parameter specifies the fonts to be used in printing variable
input data or CME data. The FONTS parameter within a DJDE takes
effect on the next page boundary.

Syntax

FONTS =

option(s)

Options

Table 8-27 lists the parameter option(s) and definition(s).

If an override line spacing value is specified, lines printed using the
font cause the indicated line spacing to be performed after the line
using the font. If different fonts are used on the same print line, the
line spacing value specified for the font of the largest character in the
line is used to determine the position of the next print line. (Refer to
the “Points to note” section.)

Table 8-27.

FONTS parameter option(s) and definition(s)

Option(s)

Definition(s)

((

f

1

,

s

1

[LPI

|

XDOTS

|

DOTS]) [, (

f

2

,

s

2

[LPI

|

XDOTS

|

DOTS]) ] [,...])

This option has the following components:

f

1

Each font index (f1) specifies a 1 to 6
alphanumeric character identifier (consisting of
at least one letter) corresponding to a font
cataloged on the system disk (up to 128 fonts
can be used with the font indexing capability
and up to 94 fonts on a single page). If the
number of fonts to be invoked exceeds the size
of one DJDE record, multiple FONTS
parameters must be used.

s

1

Each spacing index (s1) value specifies an
optional override line spacing value specifying
either lines per inch or dots per line to be
associated with the font; maximum value for s1
is 30 LPI; minimum value is 10 XDOTS or dots.
If a unit (LPI, XDOTS, or DOTS) is not
specified, LPI is used as the default.