Xerox 96MX - Manual (Page 383)

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE 8-55
SNUMBER
This parameter specifies that the printer merge the current segment
sequence number into any subsequent segment separator sheets
produced. SNUMBER can be modified as a DJDE under the
following conditions:
•
Both SEPARATORS and SNUMBER are previously defined in
either a JDE or JDL or as DJDEs.
•
If the SEPARATORS parameter is not specified in the EXPORT
command, it must be specified as a DJDE, along with the
SNUMBER DJDE.
Syntax SNUMBER = option(s)
Options Table 8-52 lists the parameter option(s) and definition(s).
Considerations lnum and cnum are interpreted using the metrics of the font specified
by findex (the same as with page numbering). Refer to the “Points to
note” section for additional information.
Table 8-52. SNUMBER parameter option(s) and definition(s)
Option(s) Definition(s)
( lnum, cnum
,[ findex])
This option has the following components:
•
lnum
Specifies the integer line number on which the
segment sequence number string is to start.
• cnum
Specifies the integer column number on which
the segment sequence number string is to end.
•
findex
Specifies fontindex of the font to be used for
printing the segment sequence number string. If
SNUMBER is specified without SEPARATORS
(under allowable conditions), the font index
refers to the font list used at the time
SEPARATORS was specified.