Xerox 96MX - Manual (Page 113)

SPECIFYING INPUT PARAMETERS
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE 4-21
LENGTH
This parameter specifies the length of the longest logical record. A
value specifies the length, in bytes, of the longest logical record.
Syntax RECORD LENGTH = option(s)
Options Table 4-26 lists the parameter option(s) and definition(s).
LMULT
This parameter specifies a multiplication factor applied to the
contents of the record length field to determine the true record length.
Syntax RECORD LMULT = option(s)
Options Table 4-27 lists the parameter option(s) and definition(s).
Table 4-26. LENGTH parameter option(s) and definition(s)
Option(s) Definition(s)
value An integer in the range 1 to 310 for offline (133 is the
default) or 150, the online default. For offline
systems, the tape label contents may override a
value. For online systems, if you define a record
length larger than the default block length (1330
bytes), you must also define a block length that is big
enough to hold the record. If a larger block length is
not specified, the default length value is used and the
system produces a warning message on the system
controller display.
The default is 133 offline, and 150 online.
Table 4-27. LMULT parameter option(s) and definition(s)
Option(s) Definition(s)
value Specifies the multiplication factor. The value
specified is multiplied by the value in the length field
to compute the number of bytes in the record. A value
is an integer in the range 1 (the default) to 15.
The default is 1.