Xerox 96MX User Manual
Page 373
SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE
8-45
OTEXT
This parameter specifies a text message to be output to the operator
during job printing. It takes effect on the next page boundary. The
parameters are the same as for the MESSAGE command defined in
the chapter "Print format commands."
Syntax
OTEXT =
option(s)
Options
Table 8-40 lists the parameter option(s) and definition(s).
Table 8-40.
OTEXT parameter option(s) and definition(s)
Option(s)
Definition(s)
NONE
Specifies that no text message is output to the
operator during job printing.
The default is NONE.
sc
Specifies a text message of up to 80 characters
(maximum of 400 characters per report).
passnum
Specifies the pass (copy ply) to which the text
applies. Multiple sc messages, one per passnum,
may be specified in a JSL. The message is output to
the operator prior to the beginning of printing the
specified report ply. If no pass number is specified,
the text is output once at the beginning of printing the
entire report.
WAIT
Specifies that after the text is displayed, printing is
suspended until the operator has responded wit a
CONTINUE parameter.
END
Specifies that the text is displayed after the last copy
of the report is printed.