Xerox 96MX - Manual (Page 333)

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE 8-5
RTEXT Specifies text to be printed on a separate page
preceding a report.
SEFMAP Specifies a font mapping table different than the one
specified in the JDL.
SEPARATORS Specifies that the next data page in a report be used to
generate segment separator sheets.
SHIFT Specifies a shift of image on the page for binding
purposes.
SF1FUNCTION Specifies sheet finisher function number 1 through the
DFA channel C6.
SF2FUNCTION Specifies sheet finisher function number 2 through the
DFA channel C7.
SIDE Specifies the repositioning of the new logical page to
the first logical page of the given side of a physical
sheet of paper.
SNUMBER Prints the segment number on generated segment
separator sheets.
SPLIT Defines the conditions for starting and ending
segments.
SRECOVER Specifies the recovery mode for sheets of paper in the
paper path.
STIMING Specifies timing parameters. Performs same function
as the Finishing Configuration Utility (FCG) but is
ignored by the system.
STOCKS Redefines the parameters of a STOCKSET command
(the types of stocks to use) for the page.
TMODE Specifies process direction measurement for
determining default pitch modes.
TRANS Specifies whether transparencies are used in the print
job.
XSHIFT Allows shifting in the x-direction for short-edge binding.
Table 8-1. Page-oriented DJDEs (continued)
DJDE Function