Xerox 96MX - Manual (Page 344)

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
8-16 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE
The selected JDE should specify all JDE parameters which stay the
same as the original JDE as well as the changes. The parameters
which can be changed through a selected JDE are listed in table 8-9.
If a front cover is invoked in a selected JDE which takes effect after
the first page of the report, a cover is pulled from the AUX tray at the
point where the DJDE is applied.
Note: CODE changes to data may occur and will take effect on the
page boundary following the DJDE record. If a translation code
change is involved in a selected JDE, the parameter portion of any
subsequent DJDE must be in the new code. The prefix used by the
IDEN must, however, retain the original hexadecimal value. Thus, if
the CODE changes from EBCDIC to ASCII, the prefix must remain in
EBCDIC even though the parameter portion changes to ASCII.
Table 8-9. Parameters which can be changed through a JDE
Command Parameter(s)
LINE DATA
FONTINDEX
MARGIN
OVERPRINT
PCCTYPE
VFU
LINE All parameters except OFFSET
VOLUME TCODE
CODE
ACCT All parameters
EXPORT All parameters
MESSAGE All parameters
PDE All parameters
ROUTE All parameters
ROFFSET All parameters
RAUX All parameters
RPAGE All parameters
RSTACK TEST (online only)