Installing the main unit on a flat surface, Refer to, Figure 58 – Nortel Networks BCM200/400 User Manual

Page 96: Figure 59

Text mode
Original mode

100

Chapter 6 Installing the BCM main unit

N0060612

Figure 58 Attach the wall-mount brackets to the BCM200 main unit

Figure 59 Attach the wall-mount brackets to the BCM400 main unit

Hang the BCM main unit on the backboard screws. Make sure the main unit is level. Ensure
the wood screw heads seat fully into the wall-mount bracket slots.

Tighten the wood screws against the wall-mount bracket.

Installing the main unit on a flat surface

Use this procedure to install the BCM main unit on any flat surface that can safely support the
weight of the unit.

Caution: Refer to

“Environmental requirements” on page 89

for acceptable

environmental conditions before selecting a location for the BCM main unit.

Install wall-mount
bracket screws