Nortel Networks BCM200/400 - Manual (Page 190)

190 Chapter 13 Initializing the system
N0060612 N0060612
To generate a keycode through the Nortel Keycode Retrieval System (KRS), you require:
• Username and password for the KRS (http://www.nortel.com/servsup/krs)
• BCM 4.0 feature authorization code for each feature
• BCM 4.0 system ID
You can apply a keycode file using:
• Element Manager (see “To enter a keycode” on page 203 )
• Startup Profile (see “Using the Startup Profile to configure parameters” on page 213 )
• Telset Administration (see “To enter the keycodes” on page 196 )
For more information on keycodes, refer to the Keycode Installation Guide.
Regenerating a keycode after system replacement
If you replace your media services card (MSC), you must regenerate your keycode file to reflect
the new system identification. Apply the keycode file after you perform your system data restore.
For more information, refer to the Keycode Installation Guide.
Next step
After connecting to the BCM system, proceed to “Configuring the BCM system” on page 191 .